Spiral bevel gear is a key transmission system component, and it is often used in many manufacturing industries. It can be said that it has shown a lot of convenience for everyone's production, so what must be paid attention to when installing spiral bevel gear?

Normally, when installing the spiral bevel gear, the axes of the two shafts should be adjusted to the same plan view, and then the assembly line for the lower components can be just started. That is to say, the coloring of the spiral bevel gear surface is checked. It should be noted that the shaft cannot be moved during the entire rotation, and the surface should be close to the short end of the transmission gear under no load.

There is also one thing that is to say that the regulations for the black spots of the mating gears are usually set at about 70% by the gear processing factory. People can also adjust the gear gaps according to the method of adjusting the thickness of the sealing gasket. For adjustment, it should be noted that the gap of the spiral spiral bevel gear can neither be too large nor too small, otherwise the application for people will have a lot of harm.

Therefore, when installing the spiral bevel gear, this key point must be done well to ensure its excellent characteristics.